Paragraph
Page
Paragraph
Page
A i r cleaner --- ----- --- -- 3-27
General methods used to attain
Arc-welding generator assembly------------ 6-13
proper radio suppression-------------- 3-15
Generator assembly, arc welder 6-13
Batteries
Generator assembly, brushes and
Battery charging generator------------- 6-3
mounting bracket ---- ---- - 3-36
Governor, engine speed ------------- 6-1
Brushes and mounting bracket,
generator assembly-------------- 3-36
Identification and tabulated data------------- 1-4
Brushholder assembly, welding
Identification
plate-----------
Inspecting and servicing equipment-------------- 2-3
Installation of separately packed
Camshaft and valve assembly
components
Carburetor
Installation or setting-up
Crankshaft, flywheel, and piston
instructions-------------------
assembly
Choke control -- 3-30
Interference suppression
Cleaner,
air
c o m p o n e n t s - - - - - - - - - - - - - - - - - - 3-16
Components, interference
suppression -------- ----
Lamp replacement------------- 3-13
Control panel assembly------------ 6-14
Lead assembly and spark plug---------- 3-35
Controls and instruments --3-56
Lubrication--------------
Magneto---------------------
C u r r e n t control------------- -6-15
Maintenance, daily preventive---------- 3-7
Cylinder head ---3-58
Maintenance operator:
Cylinder and crankcase assembly 6-12
Fuel filter service------ 3-9
Daily preventive maintenance 3-7
Fuel tank and strainer service --3-10
D a t a , tabulated------------
Fan V-belt adjustment---- 3-11
Demolition:
Carburetor adjustment----- 3-12
General
Lamp replacement--------- 3-13
Demolition by mechanical
Maintenance, quarterly preventive-------- 3-6
means
Manifold-------------------
Demolition by explosives or
Models, difference in------ 1-5
weapons fire------------------ 4-7
Movement, dismantling------- 2-7
Other demolition methods 4-8
Muffler-------------- ---3-55
Training ------ ------- 4-9
Oil pressure relief valve-------3-53
Description
Oil
pump------------
Difference in models----------------1 - 5
Operating under unusual conditions:
Dismantling for movement-------- 2-7
Operating in extreme cold----- 2-15
Doors
and
panels----------
Operating in extreme heat------ 2-17
Electrical schematic ---
Operating in dusty or sandy
Enclosure - -------- ------ -6-16
areas--------
Operating under rainy or
humid conditions------------- 2-19
Exhaust tube
Operating in salt water areas-- 2-20
Operating under usual conditions--- 2-11
Fan, V-belt adjustment------------ 3-11
Operator Maintenance:
Filter
assembly----------
Fuel
filter
service---
Fuel
filter
--
------
Fuel tank and strainer service---- 3-10
Fuel
pump
------
--
Fan V-belt adjustment-- 3-11
Fuel tank------------------6-2
Carburetor adjustment--- 3-12
Fuel tank and strainer service------
-- 3-10
Lamp
replacement----
