Figure 5-12. 400 Hz auxiliary power wire harness assembly.
(2) If self-clinching cable straps are removed
b. Disassembly.
After inspection and testing,
to facilitate repairs, install new cable straps at three inch
disassemble the wire harness only as required for repair
intervals and at all cable breakouts.
or replacement.
f. Installation. Install the wire harness assembly in
reverse order of removal procedure.
c. Cleaning and Inspection.
5-14. Anti-Ice Thermostat Wire Harness Assembly
(1) Clean wire harness with a clean, lint-free
(13217E4133)
cloth moistened with approved solvent and dry
thoroughly.
(2) Inspect for damaged or loose terminal
the anti-ice thermostat wire harness assembly as
lugs, damaged or cut wire insulation. Check for any
follows:
evidence of burned areas indicating shorts.
(1) Remove the thermostats (TS10 and TSI I
from their mounting brackets by removing two nuts and
d. Testing. Refer to the wire run chart in figure 5-
screws and four washers from each.
12 and check individual wires for continuity.
(2) Disconnect
the
connector
(P99)
and
remove the wire harness.
e. Repair, Replacement and Reassembly.
b. Disassembly.
After inspection and testing,
(1) Replace defective wires with wire in
disassemble the wire harness only as required for repair
accordance with MIL-W-5086, Type II. Wire size and
or replacement.
approximate length in inches is provided in figure 5-12.
5-16
