assembly by removing lockwire and mating connectors
and remove four nuts, four screws and eight washers
Remove lockwire, disconnect connector P34, and
from each connector (J20, J21 and J92).
remove the wire harness assembly.
(2) Replace defective wires with wire in
b. Disassembly.
After inspection and testing,
accordance with MIL-W-5086, Type II. Wire size and
disassemble the wire harness only as required for repair
approximate length in inches is provided in figure 5-10.
or replacement.
(3) If self-clinching cable straps are removed
to facilitate repairs, install new cable straps at two inch
c. Cleaning and Inspection.
intervals and at all cable breakouts.
(1) Clean wire harness with a clean, lint-free
f. Installation. Install the wire harness assembly
cloth moistened with approved solvent and dry
in reverse order of removal procedure.
thoroughly.
(2) Inspect for damaged or loose connector
After installing connectors, safety wire to the attaching
pins. Check for any evidence of burned areas indicating
hardware in accordance with MS33540 using lockwire
shorts. Inspect connectors for damaged or stripped
MS20995C20.
threads.
5-12. Recirculating Fans Wire Harness Assembly
d. Testing. Refer to the wire run chart in figure 5-
(13217E4148)
10 and check individual wires for continuity.
a. Removal.
Refer to figure 5-11; tag and
disconnect the recirculating fans wire harness as
e. Repair, Replacement and Reassembly.
follows: Figure 5-10. Recirculating fans wire harness
assembly.
(1) Solder connections will be made in
accordance with MIL-S-6872 using solder Type
SN6OWRP2 per Fed Spec QQ-S-571.
5-14
