ME-5-6115-434-35/3-13
1.
Housing
4.
Spider
2.
Pawl
5.
Ring
3.
Pin
6.
Spring
Figure 3-6. Pawls installed in spider.
(11) Insert assembled parts (4 through 8,
(9) Install ring (4, fig. 3-5) inside retainer
and 10, 12 through 17) in housing (21) after aligning
(17) to secure assembled parts (5, 6, 7). Install new
tangs on plates and rings with the two long slots on
spring (8) on bottom side of spider (7) with long flared
housing. Screw ring (11) loosely into housing, holding
end through spring hole in spider and short flared end,
up washer (10) to perform this operation.
through spring hole in retainer.
Note.
Install ring (9) after ring (11) has been
Caution: Spring (8) shall not be bent in
adjusted to give proper slip torque as described below.
toward center or out toward periphery of spider (7).
(12) Install starter (1, fig. 3-5) in clutch
(10) Bend protruding end of spring (8) to
torquing holder (special tool; see table 2-1) to prevent
approximately 45 degrees.
rotation of starter armature assembly (fig. 3-7).
3-18
