TM 5-3431-225-15
Table 4-1.
Section III. SPECIAL TOOLS AND EQUIPMENT
nance repair parts are listed and illustrated in
4-5. Special Tools and Equipment
TM 5-3431-225-25P (when published).
No special tools or equipment are required by
direct and general support and depot mainte-
4-7. Specially Designed Tools and Equipment
nance of the welding machine.
No specially designed tools and equipment are
4-6. Direct and General Support and Depot
required by direct and general support and depot
Maintenance Repair Parts
maintenance for the maintenance of the welding
machine.
Direct and general support and depot mainte-
Section IV. TROUBLESHOOTING
4-12. Welding Machine
has Internal Arcing
4-8. General
This section plovides information useful in diag-
nosing and correcting unsatisfactory operation or
(para
failure of the welding machine or any of its com-
ponents. Each trouble symptom stated is followed
4-31,
32,
by a list of probable causes of the trouble. The
33).
possible remedy recommended is described op-
posite the probable cause.
4-13. Welding Machine
Fails to
Start
4-9. Welding Machine Smokes
(para
4-31).
(para
4-14. Welding Machine
Operates Erratically
4-10. Polarity Cannot be
Selected
(para
411. Range Cannot be
Selected
(para