TM 1-4920-455-13&P
3-16. Fixtures - Air Feed Thru Connector- Inspect
3-16
This tasks covers: Inspection of connector
INITIAL SETUP
44B Welder
Personnel Required:
INSPECT AIR FEED THRU CONNECTOR
1.
2.
Remove dust cap (1) or quick disconnect (2) from
connector (3) at exterior service panel.
Inspect condition of connector threads (4). Inspect
connector weld (5) for cracks or breaks. Replace
IAW Task 3-17, if defective.
3. Install quick disconnect (2) as necessary.
4. Ensure dust cap (1) is installed when quick discon-
nect is not connected.
END OF TASK
3-19
