Figure 6-22. End play measurement.
(8) After assembly, paint end of rotor (24) shaft,
(6) Coat threads of clamps ( 17, fig. 6-15) with
hex hole in shaft, and nut (19) with one coat of primer
surface primer to dry.
Coat threads with sealant
(Cati-Coat E42GP15, mixed equal parts by volume with
(Military Specification MIL-S-224373, Class 10) and
Catalyst V66KP15) and air-dry for 15 to 30 minutes;
install screws while sealant is wet.
then bake at 150to 175F (65.to 79.4 for one hour.
)
(7)
Tighten screws on clamp (17) inside
e. Installation. Refer to TM 5-6115-586-12 for
housing (25). Install end bell (16), washers (11), and
condenser fans installation instructions.
discs (8, 9, 10), then tighten screws on clamp (17) on
outside of housing assembly (25).
6-31
