disconnect the battery wire harness assembly as follows:
f. Installation. Install the wire harness assembly
(1) Disconnect wire leads from BI, KI, K16, and
in reverse order of removal procedure. After installing
K33.
connector, safety wire in accordance with MS35540
(2) Remove lockwire; disconnect connector P64
using lockwire MS20()995C20.
and remove wire harness assembly.
5-36. Battery Wire Harness Assembly
13217E41.54)
Figure 5-49. Battery wire harness assembly.
e. Repair, Replacement and Reassembly.
b. Disassembly. After inspection and testing,
(1) Solder connections will be made in
disassemble the wire harness only as required for repair
accordance with MIL-S-6872 using solder Type
or replacement.
SN60WRP2 per Fed Spec QQ-S-571.
c. Cleaning and Inspection.
(2) Replace defective wires with wire in
(1) Clean wire harness with a clean, lint-free
accordance with MIL-W-5086, Type II. Wire size and
cloth moistened with an approved solvent and dry
approximate length in inches is provided in figure 5-49.
thoroughly.
(3) If self-clinching cable straps are removed to
(2) Inspect for damaged or loose connector pins,
facilitate repairs, install new cable straps at two inch
damaged wires, and loose or damaged terminal lugs.
intervals and at all cable breakouts.
Check for any evidence of burned areas indicating
f. Installation. Install the wire harness assembly in
shorts. Inspect connectors for damaged or stripped
reverse order of removal procedure. After installing
threads.
connector, safety wire in accordance with MS35540
using lockwire M S20()995C20.
and check individual wires for continuity.
5-64
