(3) Replace all other parts found to be
c. Repair and Replacement.
defective through inspection or testing.
(1) Repair the wire harness assembly as
d. Reassembly and installation. Refer to TM 5611
follows:
5-586-12 for reassembly and installation instructions.
(a)
Solder connections will be made in
5-31. Electrical Leads and Jumpers
accordance with MIL-S-6872 using solder Type
SNL'60WRP2 per Fed Spec per QQ-S-571.
a.
General.
This paragraph contains repair
(b)
Replace defective wires with wire in
instructions for all single wire electrical leads and
accordance with MIL-W-5086, Type II. Wire size and
jumpers used in the power plant, including the battery
approximate length in inches is provided in figure 5-4/i.
interconnecting lead. The chart in figure 546 lists wire
(c)
If self-clinching cable straps are
numbers. terminations, and assembly where the lead is
used. Locate the wire to be repaired in the listing and
removed to facilitate repairs, install new cable straps at
then follow the general instructions in this paragraph.
five inch intervals and at all cable breakouts.
(2) Bent panel may be repaired by simple shop
repair.
Figure 5-46. Electrical leads.
5-59
