Figure 5-36. Hz auxiliary output 2 wire harness assembly
(a) Solder connections will be made in
accordance with MIL-S-6872 using solder Type
manual for installation instructions.
SN60OWRP2 per Fed Spec QQ-S-571.
5-29. Receptacle Panel Assembly
(b) Replace defective wires with wire in
a. Removal and Disassembly. Refer to TM 56115-
accordance with MIL-W-5086, Type II. Wire size and
586-12 for instructions regarding removal and
approximate length in inches is provided in wire run
disassembly of receptacle panel assembly.
charts (fig. 5-34 through 5-36).
b. Cleaning and Inspection. Refer to TM 561 15-
(c) If self clinching cable straps are
586-12 for cleaning and inspection procedures for
removed to facilitate repair, replace them with new
receptacle panel assembly components.
cable straps.
c. Testing.
(2) Replace all components found to be dam
(1) Test capacitors for shorts and leakage
aged or defective.
with capacitor tester.
(3) Replace damaged nut plates and loose
(2) Refer to wire run chart in figure 5-37 and
rivets on panel. Repair bent panel and capacitor
test individual wires for continuity in the water heater
mounting brackets by simple shop repair.
wire harness.
e. Reassembly. Reassemble the auxiliary, power
tray assembly by reversing disassembly sequence given
in paragraph 5-28 b. above.
5-49
\
