Figure 3-19. Installation seal.
nut and install nut, tighten to torque value of 145 to 155
Note
inch-pounds. Bend key into slot in nut.
If key slots in retainer nut (25, fig.
(4) Coat mating surfaces of seal (23) with
replace retainer nut (25). Do not
adhesive. Using driver, install seal into retainer (21).
add shims.
(5) Install required amount of
shims (24),
(1) Install shims (24, 28), determined above,
packing (22) and assembled retainer (21)
into housing.
and install rotor of seal (23), spacer (26) and retainer nut
Secure with washers screws (20) and
screws (19).
(25).
Tighten to torque value of 15 to 20
inch-pounds.
(2) Hold gearshaft using adapter.
Using
of 145 to 155 inch-pounds. Check alignment of key lots
in retainer nut (25) and mark aligned key slot.
(3) Remove retainer nut (25) and install key
(27) on gearshaft. Apply a coat of Loctite to threads of
3-33
