APPENDIX IV
REPAIR PARTS LIST
Section I. INTRODUCTION
a. Source Codes. This column is subdivided into
1. General
four columns. The titles and information provided in
a. This manual lists repair parts for organizational,
each column are as follows:
direct and general support, and depot maintenance. It
(1) Materiel. This column lists the basic materiel
indicates the quantity of repair parts required to be
code number of the supply service assigned
stocked by organizational maintenance as their
responsibility for the part. Blank spaces denote supply
prescribed load. It indicates the guide quantity factors to
responsibility of the preparing agency.
be used for initial repair parts stockage by direct and
Other basic materiel code numbers are -
general support, and recommends quantities of repair
9-Ordnance Materiel
parts for depot maintenance. Information and data
11-Signal Materiel
contained herein serve as requisitioning reference
material, and as a guide to determine stockage
(2) Source. The selection status and source of
quantities of repair parts.
supply for each part are indicated by one of the
following code symbols:
b. Price information for stock-type repair parts may
be obtained from applicable Department of the Army
(a) P-applied to high-mortality repair parts which
type 2-series supply manuals and/or Supply
Management Data and Price List (ML) of the
are stocked in or supplied from the supply
Department of Defense Section of the Federal Supply
service
depot system and authorized for use
Catalog.
at indicated maintenance levels.
(b) P1-applied to repair parts which are low-
c. Repair parts lists are arranged as follows:
mortality parts, stocked in or supplied from
supply service depots, and authorized for
(1) Individual parts and major assemblies are
installation at indicated maintenance levels.
listed alphabetically by item name within the
(c) M-applied to repair parts which are not procured
functional groups.
or stocked but are to be manufactured at
(2) Assembly components and subassemblies
indicated maintenance levels.
are indented and listed alphabetically by
(d) X1-applied to repair parts which are not
item name under major assemblies.
procured or stocked, the requirement for which
(3) Bulk material is listed in functional group
will be supplied by use of next higher assembly
or components.
(e) X2-applied to repair parts which are not stocked.
d. Allowances are
bases
on
1,500
hours
The indicated maintenance level requiring such
operational per year.
repair parts will attempt to obtain them through
cannibalization; if not obtainable through
2. Explanation of Repair Parts and Prescribed Load
cannibalization,
Listing (Table 1)
AGO 8244A
54