Figure 3-32. Cylinder head, removal and installation.

(2) Remove old gasket from cover and

block.

(3) Inspect cover for cracks or other dam-

age. Replace cover if damaged; install new

gasket.

c. Installation.

Reverse removal procedure to reinstall the

valve tappet cover.

3-60. Adjusting Valve Tappets

a. Remove cover assembly (para 3-59).

b. Using two end wrenches and a feeler

Figure 3-33. Cylinder head bolt tightening sequence.

gauge, adjust each tappet adjusting screw so

that a slight drag is felt when 0.014 inch feel-

(3) Remove valve tappet cover as illus-

er gauge blade is withdrawn. Adjust when en-

gine is hot.

b. Cleaning and Inspection.

c. Replace cover (para 3-59).

(1) Clean cover assembly with an ap-

proved solvent. Dry thoroughly.