TM 5-3431-200-15
Section II. MOVEMENT TO A NEW WORKSITE
c. The welding set can be hand carried or
11. Dismantling for Movement
transported by hand truck to a new worksite.
a. Disconnect the welding current cable, con-
trcd power cable, and groand cable from the
12. Reinstallation After Movement
welder.
Install the welding set at the new worksite
b. Disconnect the argon gas regulator from
the source of supply.
as instructed in paragraph 10.
Section III. CONTROLS AND INSTRUMENTS
13. General
14. Controls and Instruments
This section describes, locates, illustrates,
The purpose and location of all controls and
and furnishes the operator or organizational
instruments are shown in figure 5.
maintenance personnel sufficient. information
about the various controls and instruments for
proper operation of the welding set.
8
