TABLE II
Hose and Cable Kits
Wire Hose
Wire Hose
Hose and Cable
Hose and Cable
Stock No.
Stock No.
Kit Stock No.
Length (ft. )
23601196
15
23602203
23602205
23600979
50
23602203
23602206
23601301
23602284
100
23602257
TABLE III
Cable Size Selector Guide
Feet
175 200
300
150
225
250
100
125
50
75
Amps.
2
3/0
1
1/0
1/0
2/0
2/0
100
2
2
2
2/0
3/0
3/0
4/0
2
2
1
1/0
150
1
3/0
4/0
4/0
2
1/0
2/0
200
4/0
2/0
3/0
2
1/0
250
1
2/0
3/0
4/0
300
4/0
1/0
2/0
350
1/0
3/0
4/0
400
2/0
3/0
450
2/0
4/0
500
b. Make all other gun connections as shown in Fig-
2. Place clamping bar under this cluster. Apply
ure 8.
screws and wing nuts.
c. Anchor cables and hoses and flexible shaft on
3, Tighten screws only sufficiently to hold the
strain relief (Fig. 9) to prevent straining- at connec-
cluster into place.
tion points to the - Feeder `as follows:
Be careful not to flat-
lMPORTANT:
1. Fasten hoses, casing and flexible shaft, if any,
ten the hoses excessively, Excessive
side-by-side in order of decreasing hose diameter
clamping may hinder flow through
under nose of frame. Leave a small amount of slack.
the hoses.
Section III. OPERATION
3.1 SAFETY REQUIREMENTS
goggles (medium-shade 1306 2101) are recommended
in addition to helmet for the operator and near-by per-
Comply with all ventilation, fire and other safety re-
sonnel. The welding wire (electrode) and all metal
quirements for welding as established for industrial
parts in contact with it are electrically energized while
applications. Reference as applicable:
welding, requiring periodic inspection of cables for
broken insulation, water leakage, and other electrical
a. "Safety in Electric and Gas Welding and Cutting
hazards.
Operation". . . American Standards Association:
Bulletin 249.1, 1958.
CAUTION
b. "Recommended Safe Practices for Inert- Gas
WHENEVER STEPS ARE TAKEN
Metal-Arc Welding". . . A merican Welding Society:
TO REMOVE AND REPAIR SUCH
Bulletin A6.1, 1958,
HAZARDS, PLACE ALL POWER
coNTRoLsoFF AND DISCONNECT
ALL ELECTRICAL CABLING FROM
tensity arc in AIRCOMATIC welding methods, flash
POWER SOURCES.