2.5 CONNECTING GAS AND WATER HOSES AND
a. Press down lock button (Fig. 4) on right side of
CONTROL CABLE
Gun. Slide off drive roll housing,
CAUTION
b. Back off adjusting set screw (Fig. 9) on right-
MAKE SURE ALL POWER IS OFF.
hand disc of drive roll housing to relieve pressure on
conical roll shaft.
Connect water-out and cable assembly, water-in hose,
gas hose, and control cable of the Gun to feeder ac -
c. Insert conical roll into end of conical roll shaft
cording to instructions in feeder manual.
d. Hold conical roll depressed. Insert grooved roll
into end of grooved roll shaft. Release conical roll,
2.6 WIRE GUIDE FITTINGS IN
DRIVE ROLL HOUSING
e. Lift casing catch and install inlet guide bush-
Install wire guide fittings (Fig. 8) in drive roll hous-
ing in bottom hole of drive roll housing (Fig. 11). Re -
ing as follows:
lease catch.
25