assemblies and prevent contact. The high frequency
damage leading to early failure of these parts if they are
vibration of the power plant may cause rapid wear and
incorrectly installed.
Section IV. REMOVAL AND INSTALLATION OF MAJOR
COMPONENTS AND AUXILIARIES
system electrical components panel, auxiliary power
2-10. General
tray, receptacle panel assembly, four condenser fans,
a.
The primary component of the power plant is
and four recirculating fans. Refer to paragraph 2-13 for
the engine and skid assembly which is made up of the
removal and installation instructions regarding the
following major components: a pneumatic and shaft
auxiliary power tray. Refer to TM 5-6115-586-12 for
power gas turbine engine, a 10 kw 60 Hz generator, a 90
instructions regarding removal and installation of the
kw 400 Hz generator, a lower electric power chassis
remaining major components.
assembly, an upper electric power chassis assembly,
2-11. Removal and Installation of Engine and Skid
and a skid assembly. The engine and skid assembly
Assembly
may be removed from the power plant as a unit to
facilitate removal of the engine. Removal of major
a.
Removal.
components other than the engine may be
(1) Remove the gas turbine engine access
accomplished without removing the engine and skid,
panel (2, fig. 2-5, sheet 1 of 3) by loosening stud
assembly if desired.
fasteners (1).
b.
The other major components of the power
plant are the instrument panel assembly, conditioned air
2-21
