quency and timer drawer.
(4) Refer to figure 3-4 and remove the high fre-
(2) Be sure the 10 pin connector and the two
quency and timer drawer.
banana plugs are firmly seated.
b. Installation/.
(3) Close and lock the door.
(1) Refer to figure 3-4 and install the high fre-
(3) Remove the four screws holding the fan as-
sembly to the rear panel.
Caution: Never under any circumstances oper-
(4) Remove the gas and water solenoid valves
ate the welding machine with the top and/or side
housing removed. In addition to the safety hazard,
(5) Refer to figure 3-5 and remove the housing.
improper cooling may result in damage to the
b. Installation.
power transformer and welding machine com-
(1) Refer to figure 3-5 and install the housing.
ponents.
a. Removal. Proceed as follows to remove the top
(2) Install the gas and water solenoid valves
and the
housing from the welding machine.
(3) Install the four screws attaching the fan as-
(1)
Disconnect ac power from the welding ma-
sembly to the rear panel.
chine.
(4) Refer to figure 3-5 and install the welding
(2)
Refer to figure 3-5 and remove the welding
machine
top.
machine top.
