The nozzle holder (29) is made of stainless steel and has a finger type
holding arrangement to permit easy removal of the nozzle yet provide
positive holding pressure.
The REGULATOR-VICTROMETER combination provides a compact unit assembly for
accurate regulation and measurement of gas flow. They are especially suited
for applications such as laboratory work, gas shielded arc welding, and a
variety of industrial applications.
TWO-STAGE REGULATION. The Victor HVTS 2325, Two-Stage Regulator provides
constant delivery pressure to the VICTROMETER and readjustment of the
VICTROMETER is not required, from full to almost empty cylinder contents.
INSTALLATION
Receiving
Immediately upon receipt of the equipment, make a careful examination
for evidence of damage encountered in transit.
Do not
discard any packing material without first checking it for small access-
ory items.
The gas hose, electrical control cable, and welding power cable are con-
netted to the gun. A guide tube and nylon guides for 3/64 diameter wire
are included in the gun. Uncoil the cables and hose in preparation for
connecting them to the control.
Location
The control monitor should be installed so that all parts of the work
piece to be welded can be reached with a minimum of effort. Approximately
50 feet of cable and hose are supplied with the gun. The control unit
should be located so no sharp kinks or bends are made in the gas hose.
Care should be taken to avoid dragging the cable or hose over hot work.
The distance from the welding machine to the control is not critical and
is limited only if the voltage drop due to the length and size of the
cable prevents stable welding conditions. The 115 volt supply cable may
be extended as required, within reasonable limits.
It is usually best if the control is placed as close to the work piece
as is practical, therefore making it easy for the operator to make adjust-
ments in the wire feed speed as required.
Connections
Numbers on drawing refer to the paragraph
number in the following installation instructions: