Fig.
3 Tube and Fuse Location
grip of the Control.
Attach the leads to points 157
2.3
CONNECTING
CONTROL
and 106 on TS102.
After making sure that the main power switch (Fig. 4)
is OFF, connect Control in accordance with intercon-
d. If a water-cooledgun is to be used, attacha 5/16
nection diagram (Fig. 5) as follows:
ID hose from the drain to the right hose connector.
a. Plug the power cord into a 115 VAC supply,
e. If a water-cooled gun is to be used, attach the
b. Insert the two groups of leads of the multi-con-
water hose (part of the hose and cable kit described
ductor cable (part of the hose and cable kit described
in the feeder manual) from the feeder to the left hose
in the feeder manual) through the cord grip in the
connector.
bottom of the Cent rol. Connect the group containing
the larger number of leads to the proper terminals
on terminal strip TS101. (The numbers on the leads
f. Connect a welding cable from the left hose con-
correspond to the points on the terminal strip to which
nector to the workpiece. See Table I for the correct
they attach, ) Connect the other group of leads to the
size,
proper terminals on terminal strip TS104. Secure
the cord grip.
g. Connect a welding cable from the right hose con-
c. If a secondary weld contactor is used, bring the
nector to the negative (-) terminal of the power source.
cable from the contactor coil through the" rear cord
S e e Table I for-the correct size.
TABLE 1. Cable Size Selector Guide
59
