APPENDIX D
ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT
MAINTENANCE REPAIR PARTS AND SPECIAL TOOL LISTS
Section I. INTRODUCTION
D-1. Scope
D-3. Explanation of Columns
The following provides an explanation of col-
This appendix lists repair parts, special tools,
umns in the tabular lists,
test and support equipment required for the per-
formance of organizational, direct support and
a. Source, Maintenance, and Recoverability
general support maintenance of the welding ma-
Codes (SMR).
chine.
Note. Common hardware items known to be readily
available in Army supply channels will be assigned Main-
D-2. General
tenance codes only. Source codes, Recoverability codes, and
Maintenance Allowances will not be assigned to this cate-
a. The repair parts list is arranged as follows:
gory.
(1) Individual parts and major assemblies
(1) Source
Code. Indicates the selection sta-
are listed alphabetically by item name within the
tus and source for the listed item. Source codes
numbered functional groups,
used are:
(2) Assembly components and subassemblies
Explanation
Code
Applied to repair parts which are stocked in o r
P
are indented and listed alphabetically by item
supplied from DSA /GSA or Army supply sys-
name under major assemblies.
tem, and authorized for use at indicated cate-
gories.
b. This Repair Parts and Special Tools List is
Applied to repair parts which are procured and
P2
divided into the following sections:
stocked for insurance purposes because the
(1) Prescribed Load Allowance (PLA)--Sec-
combat or military essentiality of the end item
dictates that a minimum quantity be available
tion II. A consolidated listing of repair parts
in the supply system.
quantitatively allocated for initial stockage at the
Applied to repair parts which are not procured or
M
organizational level. This is a mandatory mini-
stocked but are to be manufactured at indicated
mum stockage allowance.
maintenance categories.
Applied to assemblies which are not procured or
A
(2) Repair Parts--Section III. A list of re-
stocked as such but are made up of two or more
pair parts authorized for the performance of
units, each of which carry individual stock num-
maintenance at the organizational level.
bers and descriptions and are procured and
stocked and can be assembled by units at indi-
(3) Special Tools, Test and Support Equip-
cated maintenance categories.
ment--Section IV. Not applicable.
Applied to parts and assemblies which are not
X
(4) Repair Pavts--Section V. A list of repair
procured or stocked; the mortality of which
normally is below that of the applicable end
parts authorized for the performance of mainte,
item; and the failure of which should result in
nance at the direct support and general support
retirement of the end item from the supply sys-
level.
tem.
(5) Special Tools, Test and Support Equip-
Applied to repair parts which are not procured or
Xl
ment--Section VI. Not applicable.
stocked, the requirement for which will be sup-
plied by use of the next higher assembly or
(6) Federal Stock Number and Reference
component.
Number Index--Section VII. A list of Federal
Applied to repair parts which are not stocked. The
X2
indicated maintenance category requiring such
Stock numbers followed by reference numbers, ap-
repair parts will attempt to obtain them
pearing in all the listings, in ascending alpha-nu-
through cannibalization; if not obtainable
meric sequence cross-referenced to index number.
through cannibalization, such repair parts will
