g.
1-Year
Allowance
Per
100
Equipment's/
f.
The following publications pertain to the Power
Contingency Planning Purposes.
Plant and its components:
TM 5-6115-586-12
Operator
and
Organizational
(1) Items authorized for use as required but not for
Maintenance Manual
initial stockage are identified with an asterisk in the allowance
column.
TM 5-6115-586-34
Direct Support
and General
Support Maintenance Manual
(2) This column indicates the total quantity of special
tools required for distribution and contingency planning
purposes.
TM 5-6115-586-20P
Organizational
Maintenance
Repair Parts and Special Tools
List.
h.
Depot
Maintenance
Allowance
Per
100
Equipment's.
5.
How to Locate Repair Parts.
(1) Items authorized for use as required but not for
initial stockage are identified with an asterisk in the allowance
a.
When Federal stock number or reference number
column.
is unknown:
(2) This column indicates the total quantity of special
(1) First. Using the table of contents deter- mine the
tools authorized for depot maintenance of 100 equipment's.
assembly group within which the repair part belongs. This is
necessary since illustrations are pre- pared for assembly
(i).
Illustrated. This column is divided as follows:
groups, and listings are divided into the same groups.
(1) Figure Number. Indicates the figure number of the
(2) Second. Find the illustration covering the assembly
illustration on which the item is shown.
group to which the repair part belongs.
(2) Item Number. Indicates the callout number used to
(3) Third. Identify the repair part on the illustration and
reference the item in the illustration.
note the illustration figure number and item number of the
repair part.
4.
Special Information.
(4) Fourth. Using the Repair Parts Listing, find the
a.
Useable on codes are included in Column 3. (Not
assembly group to which the repair part belongs and locate
applicable.)
the illustration figure and item number noted on the illustration.
b.
The basis of issue for authorized special tools, test
b.
When the Federal stock number or reference
and support equipment is the number of end items of
number is known:
equipment supported and the number of maintenance
personnel allocated to perform the required maintenance
(1) First. Using the Index of Federal Stock Numbers
operations.
and Reference Numbers find the pertinent Federal stock
number and reference number. This index is in ascending
c.
Parts which require manufacture or assembly at a
FSN sequence followed by a list of reference numbers in
level higher than that authorized for installation will indicate in
ascending alpha-numeric sequence, cross-referenced to the
the source column the higher level.
illustration figure number and item number.
d.
Repair parts kits and gasket sets appear as the last
(2) Second. Using the Repair Parts Listing, find the
group in the repair parts listing.
assembly group of the repair part and the illustration figure
and item number referenced in the Index of Federal Stock
e.
(Applicable to revision and/or change only). Action
number and Reference Numbers.
change codes indicated in the left-hand margin of the listing
page denote the following:
6.
Abbreviations.
N-Indicates an added item.
Abbreviation
Explanation
C-Indicates a change in data.
AC
ALTERNATING CURRENT
ADJ
ADJUST
R-Indicates
a
change
in
FSN
only.
AIR COND
AIR CONDITIONING
ASSY
ASSEMBLY
AUX
AUXILLIARY
CONT
CONTROL
vi
