Section I INTRODUCTION
Code
Explanation
1. Scope.
P
Repair Parts, Special Tools and Test Equip-
a. This manual lists repair parts, special tools, test
ment supplied from GSA/DSA or Army supply
and support equipment required for the performance of
system, and authorized for use at indicated
direct support, general support, and depot maintenance
maintenance levels.
of the Power Plant.
P2
Repair Parts, Special Tools and Test Equip-
b. Repair parts listed represent those authorized for
ment which are procured and stocked for
use at indicated maintenance levels and will be
insurance purposes because the combat or
requisitioned on an "as required" basis until stockage is
military essentially of the end item dictates that a
justified by demand in accordance with AR 710-2.
minimum quantity be available in the supply
system.
2. General.
P9
Assigned to items which are NSA design
This Repair Parts and Special Tools List is divided
controlled: unique repair parts, special tools,
into the following sections:
test, measuring, and diagnostic equipment which
are stocked and supplied by the Army COMSEC
a. Repair Parts List-Section II. A list of repair parts
Logistic System and which are not subject to the
authorized at the direct support, general support, and
provisions of AR 380-41.
depot levels for the performance of maintenance. The list
also includes parts which must be removed for the
P10
Assigned to items which are NSA design
replacement of the authorized parts. Parts lists are
controlled: special tools, test, measuring, and
composed of assembly groups in ascending numerical
diagnostic equipment for COMSEC support which
sequence, with parts in each group listed in figure and
are accountable under the provisions of AR 380-
item number sequence.
41 and which are stocked and supplied by the
Army COMSEC Logistic System.
b. Special Tools, Test and Support Equipment-
M
Repair Parts, Special Tools and Test Equip-
equipment authorized for the performance of mainten-
ment which are not procured or stocked as such
ance at the direct support, general support, and depot
in the supply system but are to be manufactured
level.
at indicated maintenance levels.
c. Federal Stock Number and Reference Number
A
Assemblies which are not procured or stocked as
A list,
in ascending numerical
such, but are made up of two or more units.
sequence, of all Federal stock numbers appearing in the
Such component units carry individual stock
listings, followed by a list, in alpha-numeric sequence,
numbers and descriptions, are procured and
of all reference numbers appearing in the listings.
stocked separately, and can be assernbled to
Federal stock number and reference numbers are cross-
form the required assembly at indicated
referenced to each illustration figure and/or item number
maintenance levels.
appearance.
X
Parts and assemblies that are not procured or
3. Explanation of Columns.
stocked because the failure rate is normally below
that of the applicable end item or component.
The following provides an explanation of columns
The failure of such part or assembly should result
found in the tabular lists in Sections II and III:
in retirement of the end item from the supply
system.
a. Source, Maintenance, and Recoverability Code
(SMR).
X1
Repair Parts which are not procured or stocked.
The requirement for such items will be filled by
(1) Source Code.
Indicates the source for the listed
the next higher assembly or component.
items.
Source
Codes
are:
iv
