INTRODUCTION
a. Source, Maintenance, and Recoverability
Scope
1.
Codes (SMR).
This manual lists repair parts, special tools,
(1) Source code indicates the source for the
test and support equipment required for the
listed items. Source Codes are:
performance of organizational, direct support,
general support and depot maintenance of the
welding set.
2. General
This Repair Parts and Special Tools List is
divided into the following sections:
tion II. A composite
listing of
repair parts, spe-
cial tools, test and support equipment having
quantitative allowances for initial stockage at the
organizational level.
figure and item number sequence, of repair parts
authorized at the organizational level for the per-
formance of maintenance, including those items
which must be removed for replacement of the
authorized item. Items, except kits and sets, are
listed by assembly group in top down breakdown
sequence.
c. Special Tools, Test and Support Equipment
-Section IV. Not Applicable.
and item number sequence, of the repair parts
authorized for the performance of maintenance
at the direct support, general support levels, in-
cluding those items which must be removed for
replacement of the authorized item. Items, ex-
cept kits and sets, are listed by assembly group
in top down breakdown sequence.
e. Special Tools, Test and Support Equipment
-Section VI. Not Applicable.
f. Federal Stock Number and Reference
N u m b e r Index-Section VII. A
list of
Federal
Stock Numbers in ascending numerical sequence,
followed by a list of reference numbers appearing
in all listings, in ascending alpha-numeric se-
quence, cross-referenced to the illustration figure
and item number.
(2) Maintenance code indicates the lowest
category of maintenance authorized to install the
listed item, Repair parts and special tools as-
3. Explanation of Columns
signd Maintenance Code "C" may be stocked at
the operator level of maintenance when author-
The following provides an explanation of
ized by the Unit Commander. The maintenance
level codes are:
VI.