TM 5-3431-225-25P
INTRODUCTION
NOTE
1. Scope
Common harware items known to be readily
available in Army supply channels are assigned
This manual lists repair parts, special tools, test
maintenance codes only. Source codes, recover-
and support equipment required for the perform-
ability codes, and maintenance allowances are not
ance of organizational, direct support, general
assigned this category.
support, and depot maintenance of the welding
(1) Source code indicates the selection status
machine.
and source for the listed item. Source codes used
are:
2. General
Explanation
Code
This Repair Parts and Special Tools List is di-
Repair parts which are stocked in or sup-
P
vided into the following sections:
plied from the GSA/DSA, or Army
supply system and authorized for use at
a. Prescribed Load Allowance (PLA)-Section
indicated maintenance categories.
II. A composite listing of repair parts, special
Repair parts which are not procured or
M
tools, test and support equipment having quantita-
stocked, but are to be manufactured in
tive allowances for initial stockage at the organi-
indicated maintenance levels.
zational level.
Assemblies which are not procured or
A
such, but are made up of two or more
b. Repair Parts-Section III. A list of repair
units. Such component units carry in-
parts authorized for the performance of mainte-
dividual stock numbers and descriptions,
nance at the organizational level in figure and
are procured and stocked separately and
item number sequence.
can be assembled to form the required as-
sembly at indicated maintenance cate-
c. Specail Tools, Test and Support Equipment
gories.
for Organizational Maintenance-Section IV. Not
Parts and assemblies which are not pro-
X
applicable.
cured or stocked and the mortality of
which normally is below that of the ap-
d. Repair Parts-Section V. A list of repair
plicable end item or component. The
parts authorized for the performance of mainte-
failure of such part or assembly should
nance at the direct support, general support, and
result in retirement of the end item from
depot level in figure and item number sequence.
the supply system.
Repair parts which are not procured or
e. Special Tools, Test and Support Equipment
stocked. The requirement of such items
for DS and GS Maintenance-Section VI. N o t
will be filled by use of the next higher
applicable.
assembly or component.
Repair parts which are not stocked. The
X2
f. Federal Stock Number and Reference Num-
indicated maintenance category requiring
such repair parts will attempt to obtain
numbers in ascending numerical sequence, fol-
them through cannibalization. Where
lowed by a list of reference numbers appearing in
such repair parts are not obtainable
through cannibalization, requirements will
all of the listings, in alpha-numeric sequence,
be requisitioned, with accompanying jus-
cross-referenced to the illustration figure and
tification, through normal supply chan-
item number.
nels.
NOTE
Major assemblies that are procured with
G
Items not illustrated are cross-referenced to page
PEMA funds for initial issue only as
number.
exchange assemblies at DSU and GSU
level. These assemblies will not be
3. Explanation of Columns
stocked above GS and DS level or re-
turned to depot supply level.
The following provides an explanation of columns
in the tabular lists in Sections II through IV.
(2) Maintenance code indicates the lowest
a. Source, Maintenance, and Recoverability
category of maintenance authorized to install the
listed item. The maintenance codes are:
Codes (SMR) .
