TM 5-3431-207-15
(1) Salt water causes corrosive action on
(3) Start motor-generator in accordance with
metal.
Care must be taken to avoid
contact of equipment with salt water. If
contact is made, or if the unit is exposed
(4) Begin usual welding operations.
to salt spray, wash the unit with clean,
c. Operation Under Wet or Humid Conditions.
fresh water.
Warning: Be sure welder and all
(1) When the welding machine is operated
components are thoroughly dry before
outside, erect a shelter to protect the unit,
attaching to power supply.
when possible. If the erection of a shelter
is not practical, keep the machine covered
(2) Coat all exposed polished surfaces with
with a canvas. Remove the covering
an approved rust proofing material or
during dry periods and allow the unit to
cover parts with a thin coat of grease. All
dry thoroughly.
exposed nonpolished surfaces may be
coated with a thin layer of grease.
(2) Connect the welding machines source of
electrical supply.
(3) Connect the welding machines source of
electrical supply.
(3) Start motor-generator in accordance with
(4) Start motor-generator in accordance with
(4) Begin usual welding operations.
(5) Begin usual welding operations.
d. Operation in Salt Water Areas.
13