INTRODUCTION
Code
Explanation
Scope
A
Applied to assemblies which are not procured
This manual lists repair parts required for the
or stocked as such but made up of two or
performance of direct support, general support,
more units, each of which carry individual
and depot maintenance of the welder.
stock numbers and descriptions and are
procured and stocked and can be assembled
2. General
by units at indicated maintenance cate-
gories.
a. The repair parts list is arranged as follows:
Applied to parts and assemblies which are
X
(1) Individual parts and major assemblies
not procured or stocked, the mortality of
are listed alphabetically by item name within
which is normally below that of the ap-
the numbered functional groups.
plicable end item, and the failure of which
should result in retirement of the end item
(2) Assembly components and subassem-
from the supply system.
blies are indented and listed alphabetically by
X1
Applied to repair parts which are not pro-
item name under major assemblies.
cured or stocked, the requirement for which
b. This Repair Parts and Special Tools List
will be supplied by use of the next higher
assembly or components.
is divided into the following sections:
Applied to repair parts which are not stocked.
X2
(1) Repair Parts-Section II. A list of re-
The indicated maintenance category requir-
pair parts authorized for the performance of
ing such repair parts will attempt to ob-
maintenance at the direct support, general sup-
tain them through cannibalization; if not
port, and depot level.
obtainable through cannibalization, such re-
(2) Special Tools, Test and Support Equip-
pair parts will be requisitioned with sup-
porting justification through normal supply
ment-Section III. A list of special tools, test and
channels.
support equipment authorized for the perform-
C
Applied to repair parts authorized for local
ance of maintenance at the direct support, gen-
procurements. If not obtainable from local
eral support, and depot level. (Not applicable)
procurement, s u c h repair parts will be
(3) Federal Stock Number and Reference
requisitioned through normal supply chan-
N u m b e r Index-Section IV. A list of Federal
nels with a supporting statement of non-
availability from local procurement.
stock numbers followed by reference numbers in
G
Applied to major assemblies that are pro-
ascending alpha-numeric sequence cross-refer-
cured with PEMA, Procurement Equipment
enced to index number.
Missile Army) funds for initial issue only
to be used as exchange assemblies at DSU
These as-
and GSU maintenance level.
semblies will not be stocked above DSU and
The following provides an explanation of columns
GSU level or returned to depot supply level.
in the tabular lists in Sections II and III:
Note. Source code is not shown on com-
a. Source Maintenance, and Recoverability
mon hardware items known to be readily
Codes (SMR), Column (1).
a v a i l a b l e in Army supply channels and
(1) Source Code, indicates the selection sta-
through local procurement.
tus and source for the listed item. Source codes
(2) Maintenance Code, indicates the lowest
used are:
category of maintenance authorized to install the
Explanation
Code
listed item. The maintenance level codes are:
Applied to repair parts which are stocked in
P
Explanation
Code
or supplied from DSA/GSA or Army Sup-
O
ply system, and authorized for use at in-
Organizational maintenance
dicated maintenance categories.
F
Direct support maintenance
H
General support maintenance
Applied to repair parts which are not pro-
M
Depot maintenance
D
cured or stocked but are to be manufactured
at indicated maintenance categories.
