TM 5-3431-200-15
C1
TECHNICAL
MANUAL
Operator, Organizational, Field, and Depot Maintenance Manual
WELDING SET, ARC, INERT GAS SHIELDED: PLASTIC OR METAL LINED GUN; FOR 3/64 IN.
WIRE; DC, 115 V (WESTINGHOUSE MODEL SA135) FSN 3431-879-9709
HEADQUARTERS,
TM
5-3431-200-15
DEPARTMENT OF THE ARMY,
25, D. C., 1 2 F e b r u a r y 1 9 6 3
W
C HANGES No. 1
ASHINGTON
TM 5-3431-200-15, 29 August 1962, is changed as follows:
f u t u r e correction, to be made as soon as opera-
P a g e 3 , p a r a g r a p h l d , lines 4 and 5. Delete
t i o n has ceased, Stop operation immediately if
"U.
S.
Army
Engineer
Maintenance
Center,
a deficiency is noted during operation which
ATTN:
EMCDM-S",
and
substitute
U.
S.
w o u l d damage the equipment if operation were
Army
Mobility
Support
Center,
ATTN:
continued. All deficiencies and shortcomings
SMOMS-MS.
will be recorded, together with the corrective
2. Record and Report Forms
action taken, on DA Form 2404 (Equipment
(Supersed)
I n s p e c t i o n and Maintenance Worksheet) at the
a. D A F o r m 2 2 5 8 ( D e p r e s e r v a t i o n G u i d e o f
earliest
possible
opportunity.
Engineer Equipment).
b. F o r o t h e r r e c o r d a n d r e p o r t f o r m s a p p l i -
(Superseded )
c a b l e to the operator and organizational main-
t e n a n c e , refer to TM 38-750.
This paragraph contains an illustrated tab-
Note. Applicable
forms,
excluding
Standard
Form
46,
ulated
listing
or
preventive
maintenance
serv-
which
is
carried
by
the
operator,
will
be
kept
in
a
i c e s which must be performed by the operator.
canvas
bag
mounted
on
the
equipment.
Daily services retain the same item numbers
P a g e 7, paragraph 8a, line 1. Delete "before
u s e d in quarterly preventive maintenance serv-
operation" and substitute daily preventive
ices. Therefore, daily preventive maintenance
maintenance.
s e r v i c e s may not be numbered consecutively but
Page 10, paragraph 16a, lines 1 and 2. De-
s h o u l d be performed in the numerical sequence
lete "before operation" and substitute d a i l y
a s shown to insure complete coverage. Refer to
preventive
maintenance.
figure 8 for the daily preventive maintenance
P a r a g r a p h 17b. R e s c i n d e d .
services.
28. General
Paragraph 30. Rescinded.
(Superseded)
31. Quarterly Preventive Maintenance
To insure that the welding set is ready for
Services
operation at all times, it must be inspected
(Superseded)
systematically, so that defects may be discov-
e r e d and corrected before they result in serious
a. This paragraph contains an illustrated
damage or failure. The necessary preventive
tabulated listing of preventive maintenance
m a i n t e n a n c e services to be performed are listed
s e r v i c e s which must be performed by organiza-
and described in paragraphs 29 and 31. The
tional maintenance personnel at quarterly in-
i t e m numbers indicate the sequence of minimum
t e r v a l s . A quarterly interval is equal to 3 cal-
inspection requirements.
Defects discovered
endar months, or 250 hours of operation, which-
d u r i n g operation of the unit will be noted for
e v e r occurs first.
1