TM 1-4920-455-13&P
3-25. Fixed Equipment/Components - Removal/Installation
3-25
This tasks covers: Removal/Installation of fixed equipment/components
INITIAL SETUP
Tools:
Shop Set, Tool Crib, NSN 4920-00-472-4183
44B Welder
Personnel Required:
REMOVAL/INSTALLATION
1. REMOVE/INSTALL FIXED EQUIPMENT.
NOTE
Permanently installed equipment should not ordinarily be removed or
relocated. However, in the event that it becomes necessary to remove,
reinstall or replace fixed equipment within the shelter, care must be
taken to remove all bolts, washers and nuts and save them for reuse.
a.
b.
c.
Remove all bolts (1), lockwashers (2), washers (3)
and nuts (4) from shop equipment. Remove equip-
ment.
Install new or repaired equipment. If new equip
ment has different mounting brackets, remount
equipment as follows:
1.
2.
3.
Mark new mounting location on bench top.
Drill holes.
Align shop equipment.
Install bolts (1), lockwashers (2) washers (3) and
nuts (4).
GO TO NEXT PAGE
3-38
