TM 1-4920-434-13&P
0018 00
100A CIRCUIT BREAKER
Inspect
Visually inspect 100A circuit breaker for any apparent damage.
WARNING
All power to shelter must be turned OFF before proceeding with any electrical
tests or repairs.
CAUTION
This work should be performed by a qualified electrician.
Remove
1. Tag and disconnect shelter electrical power.
2. Set all circuit breaker switches to OFF position.
NOTE
This procedure covers obsolete NQOB circuit breaker panel and new NQOD
circuit breaker panel. These units are distinguishable by nameplates attached to
panel boards.
3. Open circuit breaker panel door on both models.
4. Loosen four captive screws and move clamp fingers to OPEN position on model NQOB.
5. Lift circuit breaker panel cover from panel board on model NQOB.
6. Remove four screws and washers and lift panel board from circuit breaker box on both models.
NOTE
Once panel boards are removed, all further procedures are identical for both
models.
7. Reconnect site power.
