(8) Tie wires at all junctions and at all
(3) Inspect
connectors
for
crossed,
other places as required with cable tie strap.
stripped or peened threads and for bent, broken, or
otherwise damaged pins.
g.
Reassembly. Assemble harness assembly in
e.
Test.
Refer to figure 3-3 and check
reverse order of disassembly.
individual wires for continuity using a multimeter.
h.
Installation.
f.
Repair and Replacement.
(1) Install harness in reverse order of
removal procedure, using figure 3-1 as a guide and
(1) Replace any part that does not meet
observe the following.
inspection requirements and is damaged beyond simple
repair. Solder all connectors except thermocouple
(2) Remove all paint from starter flange
terminals according to Military Specification MIL-S-6872
before attaching harness ground wire. Use starter motor
using solder in accordance with Federal Specification
attaching nut to attach harness ground wire to starter
QQ-S-571, Composition Sn60.
flange.
(2) Solder
thermocouple
terminal
(3) Lockwire (terminal board, cover)
according to Military Specification MIL-S-6872 using
according to Military Standard MS33540.
solder in accordance with Federal Specification QQ-S-
3-3. Plumbing Installation
561, Class 5.
a.
General. The engine and skid plumbing
(3) If wire (22, fig. 3-3), or wire (23)
installation provides interconnection of fuel, lubrication,
require replacement, use wire in accordance with
and bleed air system components.
The hose
Military Specification MIL-W-5846B, Type II, Class A.
assemblies consist of metallic-braid-protected hoses
(4) If wires (25, 26, 27, or 29, fig. 3-3)
with permanently secured end fittings. Support clamps
require replacement, use wire in accordance with
hold the tube and hose assemblies in place and prevent
Military Specification MIL-W-25038, Size 18.
them from directly contacting the skid where they would
(5) All other wire to be in accordance with
be subject to early failure due to vibration. Tag the hose
Military Standard MS27110-18.
and tube assemblies before removal, and note location
of clamps and routing of plumbing as an aid at
(6) Identify all leads with wire number in
installation.
accordance with figure 3-3.
b.
Removal.
Remove hose and tube and
(7) If connector and terminal location
plumbing fittings according to sequence of index
markers are damaged or missing, apply new markers.
numbers 1 through 193 assigned to figure 3-4.
3-5
