TM 5-3431-207-20P
(1) The allowance columns are divided into
Code
Explanations
four subcolumns.
Indicated in each
O
Organizational maintenance
subcolumn is the quantity of items
authorized for the number of equipments
(3) Recoverability Code, indicates whether
supported. Items authorized for use as
unserviceable items should be returned
required but not for initial stockage are
for recovery or salvage. Items not coded
identified with an asterisk in the allowance
are expendable. Recoverability codes
column.
are:
(2) The
quantitative
allowances
for
Code
Explanation
organizational level of maintenance
represents one initial prescribed load for a
R
Applied to repair parts and assemblies which are
15-day period for the number of
economically repairable at DSU and GSU activities
equipments supported.
Units and
and normally are furnished by supply on an
organizations
authorized
additional
exchange basis.
prescribed loads will multiply the number
of prescribed loads authorized by the
T
Applied to high dollar value recoverable repair parts
quantity of repair parts reflected in the
which are subject to special handling and are
appropriate density column applicable to
issued on an exchange basis. Such repair parts
normally are repaired or overhauled at depot
the number of items supported to obtain
maintenance activities.
the total quantity of repair parts
authorized.
U
Applied to repair parts specifically selected for
salvage by reclamation units because of precious
(3) Organizational
units
providing
metal content, critical materials, high dollar value
maintenance for more than 100 of these
reusable casings or castings.
equipments shall determine the total
quantity of parts required by converting
(4) This column also lists, below the SMR
the equipment quantity to a decimal factor
code, an index number for each item in
by placing a decimal point before the next
ascending numerical sequence, which is
to last digit of the number to indicate
used to locate items in the publication
hundredths, and multiplying the decimal
when. the Federal stock number and/or
factor by the parts quantity authorized in
reference number is known.
the 51-100 allowance column. Example,
authorized
allowance
for
51-100
b. Federal Stock Number: This column indicates
equipments is 40; for 150 equipments
the Federal stock number for the item.
multiply 40 by 1.50 or 60 parts required.
c. Description: This column indicates the Federal
(4) Subsequent changes to allowances will be
item name and any additional description of the item
limited as follows: No change in the
required. A part number or other reference number is
range of items is authorized. If additional
followed by the applicable five-digit Federal supply code
items
are
considered
necessary,
for manufacturers in parentheses. Material required for
recommendation should be forwarded to
manufacture or fabrication is identified.
U. S. Army Mobility Equipment Command
for exception or revision to the allowance
d. Unit of Issue: This column indicates the unit
list. Revisions to the range of items
used as a basis for issue, e.g., ea, pr, ft, yd, etc.
authorized will be made by this Command
based upon engineering experience,
e. Quality Incorporated in Unit Pack: This column
demand data, or TAERS information.
indicates the actual quantity contained in the unit pack.
h. Illustration, Column (8). This column is divided
f. Quantity Incorporated in Unit: This column
as follows:
indicates the quantity of the item used in the functional
group.
(1) Figure Number Column (8a). Indicates
the figure number of the illustration in
g. Fifteen-Day
Organizational
Maintenance
which the item is shown.
Allowance, Column (4) of Section II (and Column (7) of
Section III and IV.
IV
