0057 00
TM 1-4920-445-13&P
INSTALLATION CONTINUED
NON-METALLIC HOSE AND FITTINGS CONTINUED
3.
Reinstall loop clamps (Figure 7, Item 1) with bolts (Figure 7, Item 2) in original position and secure.
INSPECTION OF INSTALLED ITEMS
OIL AND WATER SEPARATOR
NOTE
Remove center gauge if necessary to tighten bolts.
Figure 8.
Inspect Oil/Water Separator.
1.
Inspect oil/water separator hardware (Figure 8, Item 2 through 4) for rust, cracks, and rounded heads.
2.
Replace oil/water separator hardware (Figure 8, Item 2 through 4) as necessary.
If necessary, torque bolts (Figure 8, Item 4) 100- 140 in. lbs.
3.
4.
Inspect oil/water separator (Figure 8, Item 1) for damage that would deem oil/water separator (Figure 8, Item
1) non-operational.
5.
Replace oil/water separator (Figure 8, Item 1) if deemed non-operational.
REMOVAL
OIL AND WATER SEPARATOR
1.
Remove non-metallic hose IAW Non-Metallic Hose and Fittings, REMOVAL .
2.
Remove two bolts (Figure 8, Item 4), two lock washers (Figure 8, Item 3), two lat washers (Figure 8, Item 2),
and oil/water separator (Figure 8, Item 1).
0057 00-6
