0016 00
TM 1-4920-434-13&P
NOTE
This setting of the anchor is required to turn the anchor in the ground so that it
develops maximum holding power.
5. Insert driving rod through loop and pull up sharply to ensure anchor is set into ground.
NOTE
When moving shelter, disassemble storm configuration kit and cut cable as close
to ground as possible. Discard cable components. Retain the two tiedown rings
and store in appropriate storage location.
6. Remove clamp, loop cable at six places (two with tiedown rings) as shown.
7. Replace clamp and tighten clamp nuts.
0016 00-4
