to facilitate repairs, install new cable straps at five inch
disconnect the temperature sensors wire harness
intervals and at all cable breakouts.
assembly as follows:
f. Installation. Install the wire harness assembly in
connectors P85 and P93; then remove nuts, washers
reverse order of removal procedure. After installing
and screws that attach connectors J85 and J93.
connector, safety wire in accordance with MS35540
using lockwire MS20995C20.
(2) Disconnect wire leads to temperature
sensors (RT1, RT2, RT3, and RT4). Remove sensors
from mounts by removing nuts, washers and screws.
(3) Remove seven loop-type cable clamps
and remove wire harness.