and approximate length in inches is provided in figure 5-
b. Disassembly.
After inspection and testing,
18 and 5-19.
disassemble the wire harnesses only as required for
repair or replacement.
(3) If replacement of connector J45 or J47 is
necessary. remove potting compound and unsolder
electrical leads. Fill connector backshell with silicone
c. Cleaning and Inspection.
rubber sealing compound (510 RTV and Catalyst 501A.
Dow Corning Corp., Midland, Michigan, or equivalent) at
(1) Clean wire harness with a clean. lint-free
reassembly.
cloth moistened with an approved solvent and dry
thoroughly.
(4) If self-clinching cable straps are removed
(2) Inspect for damaged or loose connector
to facilitate repairs, install new cable straps at five inch
pins. damaged wires. and loose or damaged terminal
intervals and at all cable breakouts.
lugs. Check for any evidence of burned areas indicating
shorts. Inspect connectors for damaged or stripped
f. Installation. Install the wire harness assemblies
threads.
in reverse order of removal procedure. After installing
connectors. safety wire in accordance with MS35540
d. Testing. Refer to the wire run chart in figure
using lockwire MS20995C20.
518 or 5-19 as applicable and check individual wires for
Assembly 113217E4152)
e. Repair, Replacement and Reassembly.
a. Removal.
(1) Solder connections will be made in
harness assembly as follows.
accordance
with MIL-S-6872
SN60OWRP2 per Fed Spec QQ-S-571.
(2) Replace defective wires with wire in
accordance with MIL-W-5086, Type II. Wire size
5-26