INTRODUCTION
Section I.
GENERAL
Commanding General, U . S. Army Mobility
E q u i p m e n t Command, ATTN: AMSME-MPP,
This manual is for your use in operating and
4300 Goodfellow Boulevard, St. Louis, Mo. 63120.
maintaining the welding shop, trailer mounted
(Libby Model Unassigned). Chapter 1 provides a
1-4. Equipment
Serviceability Criterial (ESC)
complete description of the welding shop. The
This equipment is not covered by an ESC.
manual is intended for use by the operator,
1-5. Destruction o f A r m y M a t e r i a l t o
organizational and direct support maintenance
Prevent Enemy Use
personnel.
Instructions for destruction of material to prevent
1-2. Maintenance Forms and
Records
enemy use will be in accordance with TM 750-244-
Maintenance forms and records that you are
3 (Procedures for Destruction of Equipment to
required to use are explained in TM 38-750.
Prevent Enemy use).
1-6. Administrative Storage
The direct reporting of errors, omissions, and
Preparation, care and removal of equipment in
recommendations for improving this publication by
administrative storage will be in accordance with
the individual user is encouraged. Reports should
the applicable requirements of TM 740-90-1
be submitted on DA Form 2028 (Recommended
(Administrative Storage of Equipment.)
Changes to Publications) and forwarded direct to
Section II.
DESCRIPTION AND DATA
oxygen and acetylene necessary for oxyacetylene
cutting torches. Tools and other equipment needed
a. General. The
welding shop (fig. 1-1 and
1-2)
to perform cutting and welding operations are
covered by this manual is basically a 300 amp
included and are stored in the shop's tool boxes.
welding machine mounted on a two-wheel trailer
b. Welding Machine. The welding machine is a
chassis. Included in the shop is an inert gas welding
Libby Model LT0300. For a complete description,
gun and control used in welding either ferrous or
refer to TM 5-3431-221-15.
non-ferrous metals. Also included are the bottles